| |
|
 |
|
Deal
with and construct the points for attention the new or old
wall body surface inside and exterior:
|
As for the
coatings the proper surface plan is essential, the prepares
of coatings is waste time ,but if we want to attain the
effect on the coatings was satisfactory, this kinds of
the prepare work is not neglect. Please believe: "
cost in surface plan times at work is more important than
spending really".
We must let the wall body be dry completely and insure
the best affect of the coatings, If the color is very
high : Before the coatings ,you'd better check with the
hygrometer(湿度计) . It clears up the surface and any take
off drip one, we will prepare and mend flat with cement
mortars at the large-scale cracks and sunken , But it
needs pay attention to if its material excessively coarse,
because it suck water the differences of rate, This may
influence last coating the result of putting . |
Deal with the surface of the new wall body inside and
outside the room:
In the room --Let wall be completely dry and clear up
.To the tiny hole in a utensil, crack, the coatings have
mend flat function, but the bigger sunken and crack need
to mend flat with cement mortar .At the same time, we
are take off the surface loose. The edicts of body must
have been clean up and dry completely. After drying it
begins to paint, in order to make the affect achieved
the best ,we may spread the coating on whole wall. Care
for the above all around, we should guarantee under 10%
of moisture content.
|
Deal with the surface of the old wall body inside and
outside the room:
In the room ,we must keep firm and intact, it is still
close surface for cement to wipe, and does not have any
cracked thing . For the damage, we must brush the float
scattered material with iron brush and mend well, the
coating after this dry. clearing up with iron. Any loose
to accumulate dust, must brush completely except that
or wash. Apply surface and former to have install coating
and when surface still intact close, brush and pay attention
to clean to apply and install directly dust of surface
bits that install already. Plaster shrink, building sink
into slightly, even people go upstairs what have been
in surface cause crack, we give proper to pack and supplement
flat it. If it have bubble or phenomenon that peel off,
it need blow completely and coating surface clear up.
The surface have been coatings already is still intact
on the wall, but because of the surface were so damage
that it configured the phenomenon of ization , Though
it is the getting more time by the artificial deal with
the surface , definitely can't coating above at direction,
otherwise ,after a while the damaged degree have been
the getting more serious. |
|
|
|
|
|
|
 |
|
|
|
